Decorative Vector Ornaments: Papercut 087

Decorative Vector Ornaments: Papercut 087

This is papercut 087 of my epic papercutting project (using the “922 Decorative Vector Ornaments” book).  I’m adapting the designs for papercutting, and then practising by cutting out 100 designs in 100 days. Eventually I may may incorporate them in future papercuts that are made by laser and also by hand.

I honestly think I am getting better at this, little by little!papercut 087 with pen for scale - Kay Vincent - LaserSister

The cut-lines are getting much cleaner. OK, the large circles are still a bit wobbly, but a lot of the other shapes are quite good.

papercut 087 - Kay Vincent - LaserSister

I might admit to cheating a bit, because whereas before I used to say “it would look better up close if I tidied some of the cuts up” — I’m actually tidying the cuts up before I take the photos now 😉

Laser-cut Personalised Jewellery Holders

This week I’ve been experimenting with designs for a personalised laser-cut jewellery holder. Free cutting file included for you to try it yourself!

Laser-Cut Jewellery Holder

Here is something I’ve been playing with this week – the design of a laser-cut jewellery holder.

I made one for my mum last Christmas…

As you can see, it can hold lots of different types of jewellery (rings, necklaces, bracelets, watches, earrings). However, it still needs some tweaks.

What I like about it is:

  • As mentioned above, it can hold nearly all types of jewellery. The only exceptions I can think of at the moment are hat pins, scarf pins or brooches.
  • You can see all of the jewellery in one place. It’s not in a drawer or box, so you get to enjoy your favourite pieces like mini artworks.
  • It’s personalised and therefore unique.
  • It’s versatile, so (e.g.) the same horizontal bar can take either hook-type earrings or post-type earrings, and the vertical side bits can hold either rings or bracelets or watches.

Things to improve on the design:

  • Create a way to hang it so that it is held away from the wall, to make it easier to hang earrings.
  • Have a way to store brooches and pin-type jewellery (e.g. a tray at the bottom)

As a very basic version though, this is the design that I used:

If you’ve got a laser cutter and you’d like to have a play with this design yourself, I’ve made a vector file available below.

(Click here for basic jewellery holder design for lasercutting)

Basic jewellery holder design for lasercutting - copyright Kay Vincent - LaserSister 2018

Hope you found this post useful! If you think it might be of use to other makers/designers, please feel free to share the link to the post via Twitter (@LaserSister), Pinterest, Facebook (@LaserSister), etc…