papercut 112 leaves and vine - LaserSister

Papercutting Project (Continued): Vine and Leaves K112

(Still working on the papercutting project where I’m adapting and hand-cutting my way through the designs in the “922 Decorative Vector Ornaments” book.) This week is a really tiny and fiddly design, of a vine and leaves. 

(Note: some of the links below are affiliate links. If you’d like to find out more then please check out my policies page.)

papercut 112 leaves and vine - LaserSister

Leaves and Vine Papercutting K112

Design number 112 from the book is a simple-looking image, but because it’s so small it was really tricky to cut.

papercut 112 leaves and vine closeup- LaserSister

Unlike the previous (owl) design, I didn’t tidy up the piece after I’d cut it, and so it’s got loads of ‘threads’ hanging off it, and has gone a bit thin in one section of the vine. But that is only when you see the piece really close up. When I just look at it without any magnification, it seems fine.

Closer up:

papercut 112 leaves and vine closeup- LaserSister

So yeah – I could definitely tidy it up a lot more, but I think I’ll just leave it as it is for now, because I still like the design.

Any comments about the design, or advice about the cutting? You can chip in via the comments page, or Facebook, Twitter, LinkedIn or Instagram.

Leave a Reply

Your email address will not be published. Required fields are marked *